ohxxxyes: Rikki’s Task: DIY Micro Bikini 1. You’ll need rubber bands (the ones in
ohxxxyes: Rikki’s Task: DIY Micro Bikini 1. You’ll need rubber bands (the ones in offices), superglue and balloons, preferably big colorful ones or even glow in the dark.2. We’re going to need 5 balloons in total (3 for the bottom, 2 for the top). For the bottom, we’ll have two balloons for the front half and 1 for the back half. With this is mind, it’s easy to decide what color combinations you want to use.3. We’ll start out by cutting our 5 balloons. First cut off the nuzzles like in picture 1. Proceed be cutting along the edge in a straight line like picture 2. The end result should look more or less like picture 3.4. Now we’ll start working with only 2 balloons (the front halves of the bottoms). So take 2 cut balloons and make 3 holes in them (picture 4) also make on in the lower end of the balloons.5. Next, we’ll make the back half of the bottoms make hole like in picture 5. That’ll be all for the bottoms.6. For the top we take our two remainder cut balloons and cut like in picture 67. Proceed by making holes in both balloons like in picture 7.8. Now we’re going to connect all the pieces with rubber bands. Cut 10 rubber bands9. For the front of the bottoms we’ll take the two front pieces (by the 3 holes side by side) and put them together with one rubber band, the way shoe laces are in shoes.10. Now we’ll connect the front with the back. The singular holes on the bottom (see pictures) of each balloon are to be connected using a rubber band. Glue the rubber band back together. Then glue the entire side of the rubberband to the other.11. Next we’ll connect the sides. Put the rubber bands through the holes at the side and tie them back together. (I’ve noticed if you glue them back together they’re more likely to rip. The bottom is finished now.12. For the top we’re going with a collar design, put an uncut rubberband around your neck. Not to tight? Then let’s proceed. Tie 2 rubber bands around your collar. The connect one rubber band to the lower part of picture 6 or 7. Do the same for the other band.13. Tie two rubber bands together,14. Stick them through all of the upper holes in the design (picture 6 or 7)15. Try on your amazing new micro bikini. Personally I like my result. Feel free to share yours or you designs. -- source link